General Electric Air Conditioner Error Codes

General Electric air conditioner error codes are often accompanied by audible signals, such as beeping, to indicate specific problems. Understanding the meaning of these error codes is essential for troubleshooting. If the buttons on your GE air conditioner are unresponsive, professional assistance may be required.

---

GE Portable Air Conditioner Error Codes

Error Code	Meaning	Solution
P1 or H8	Water tank full	Drain the water tank according to the instructions in the user manual.
E1 or F1	Ambient temperature error
E2 or F2	Evaporator sensor error
E4	Display panel communication error
F4	Outdoor temperature sensor error
F0	Refrigerant sensor error
E5	Overcurrent protection error
H3	Compressor overload protection error
E8	Overload malfunction error

---

GE Window Air Conditioner LED Error Codes

LED Error Code	Meaning	Solution
Flashing “88” on LED display	Normal during startup for 2 seconds	No action required.
Flashing Cool LED light	Frozen evaporator coils	Turn off the unit and allow it to defrost. Clean the evaporator coils.
Flashing Red LED light	Dirty air filter	Clean the air filters.

---

GE Window Air Conditioner Error Codes

Error Code	Meaning	Solution
E1	Electronic control board malfunction	Restart the unit’s electronic control board.
E2	Temperature sensor error	Restart the unit.
E4	Drain tray full	Empty the drain tray.
E8	Overload malfunction error	Unplug the unit for 30 seconds to reset it.

---

GE Mini-Split Air Conditioner Error Codes

Error Code	Meaning	Solution
PE	Main compressor sensor malfunction
E0	EEPROM parameter error
E1	Communication error between indoor and outdoor units
E2	Signal error
E3	Indoor fan speed malfunction
E5	Open or short circuit in outdoor temperature sensor
E6	Open or short circuit in ambient temperature sensor
P0	Inverter module protection
P1	Overvoltage or undervoltage protection
P2	Compressor temperature protection
P3	Outdoor temperature too low
P4	Compressor drive error (inverter only)

---

GE Dehumidifier Air Conditioner Error Codes

Error Code	Meaning	Solution
E0	For 70-pint models: Water not pumping while in pump mode; E0 and pump light will flash on display.
E1	Electronic control board malfunction	Inspect the electronic control board for damage. Replace defective components.
E4	Water bucket full or float switch malfunction	Empty the water bucket. Check for pinched or damaged wires between the control panel and the float switch.
88	“88” displayed when power is connected, this is normal.	No action required.

---